Make sure that, heat passes at each and every gap in the remote control so that water content will easily and instantly get dry. Because filament bulb will get hot within very less time and keep remote control for some time under. Then place the remote control in a hot place, ultimately it is better to place the wet remote control under the filament bulb, and turn on the bulb. Why we are using cotton cloth here to clean? Because cotton cloth will absorb water content instantly from the surface of the remote control. Then clean the body and the gaps between the button and remote control well with a towel or cotton cloth. What to do when your remote control got wet by water?įirst of all, you need to shake the remote control well where all the water content on the remote control discharge from it.
#Will remoter work after water how to#
How To Fix A Remote Control That Got Wet? Immediately Dry Remote control from wet Circuit board damage due to the stain or spots that formed in circuit board.But a remote control dipped in water for more time, obviously your remote control gets damaged due to water wet completely. In most remote control it is tightly closed, with very little chance of passing the water via this gap. Here the gap between the upper and lower body is very low. See: How To Protect remote control from damaging But passing a high amount of water content surely will cause issues.Īnyway, it is good to dry your remote control as soon as got wet by water in order to avoid the possibility of passing water into the inner side of the remote control and avoid all possible damage that may cause. But passing very small water may not have a problem since there is a mat is present between the button and the circuit board so that it is very little chance of getting water into the circuit board. When water particles passed via this gap, that will cause water to accumulate under the button.
This gap is enough to pass the water inside the remote control and cause damage to it. In the first image below, see the gap between the remote control button and the remote body. Passing water through the gap between the button and the remote control body is very quick when compared to water passing Via the central gap of the remote control since it is tightly closed. Mostly, the water we problem, remote control buttons will not work due to water accumulation on circuit board, where water passes tough the small gap between the remote control body and the button edges. There is no matter when got wet only the body of the remote control. There are possibilities to get some water, tea, coffee or any other liquid like juice poured into the remote control and got wet. Remote control will get fully wet when it fell in the water and dipped completely. Your remote control may stop working completely when it got about 100% wet. What Happens When A Remote Control Got Wet By Water, Tea, Coffe Or Juice? This is a simple home remedy where you can try at your home. Anyway, today in this post I am going to show you how to fix a remote control that got wet water, Tea, coffee, or any other liquid. One of the best options not to wet remote control is, just keep away remote control when we are drinking something or give a close concentration. It is quite natural remote control got wet from tea, coffee, or water when we drink and use the remote control simultaneously. Find out the best ways to fix the wet remote control. Got wet your remote control by water, Tea, or coffee?.